- Simple PIR Wiring
- Adding TS0870 Smart Card Readers to a Four Door Controller
- ALARM - Report Fail Ademco No High Speed Acknowledge
- Area state to grant/deny door access for specific users.
- Automatic Arming and Disarming using a Timezone & Warning Timer
- Boot loader driver install for Challenger 10 -Third-party INF does not contain digital signature Information
- Challenger - How to use the Door Interlock feature on Door Controllers
- Challenger 10 - Wireless DGP Compatibility
- Challenger 10 Firmware Update (V10-04-4479) (Superseded Version)
- Challenger 10 Key Features
- Challenger 10 TCP/IP - UDP/IP connection setup
- Challenger Converting a subnet to binary
- Challenger10 Firmware Upgrade
- Challenger10 is not detected by the firmware loader software
- Challenger10 upgrade to retain V8 numbering schema
- ChallengerPlus migration from Titan to CTPlus
- Converting a TS0816 Challenger to support IUM Raw Card Data
- Converting to IUM
- Default door/lift controller Input and Relay numbering.
- Deny Access if Area is Secured using a soft time zone
- Dialler Cable Wiring for V8 Challenger
- Direct Connect Via J15 Serial Wiring on a V8
- Event code reporting for Challenger10 and ChallengerPlus (CID Reporting )
- How to make RASs 'beep' during Entry/Exit Timer
- How to program cards with Smart Card Programmer (TS0870P)
- How to turn siren off when input is still unsealed
- In-Out Readers Addressing on Four Door Controller Sub LAN
- Incorrect input alarms reported on Contact ID after upgrade from Challenger v8 to Challenger10
- Incorrect Windows driver issues with Challenger10 USB
- Input and Relay numbering chart for V8 Challenger Panel's and DGP’s